Cold air intake systems has a vital function in a car. There are numerous brands that differ in torque, horsepower, makes where used, crucial components etc.

The temperature of the air entering the engine of the car is lowered by a cold air intake system. Due to this the power of the engine is raised. Cold air is more dense than warm and humid air. Thus, a given volume of air has more oxygen. Consequently, the combustion in the engine is better. The same or more fuel economy provides more horsepower.

Cold air intake brands

Velocity cold air intake systems may have 6.8 horsepower gain and 7.1 ft-lb of torque at 5000 rpm. There is a high quality polished intake accompanied by superior performance gains. There is a high performance air filter and a mandrel bent polished intake tube. This system is used in vehicle makes like Cadillac, Chevrolet, GMC, Hummer, Nissan, Toyota, Dodge, Ford, Jeep and Lincoln.

Kool Vue cold air intake systems can have 11.3 horsepower gain at 5500 rpm and 10.9 ft-lb of torque at 5250 rpm. This is made of 6061 Aluminum. The system delivers more power through the vehicle's full rpm range using mandrel bent piping and a reusable high flowing air filter.

K&N cold air intake systems might have 17.54 horsepower at 4917 rpm. The reusable filter is more durable and generates more power. The large filter area can raise service intervals upto 100,000 miles. Vehicle makes like Acura, Jeep, Porsche, Land Rover, Chrysler etc have these systems.

AEM cold air intake systems have a short ram air intake and a polished, dry flow filter. These have a new dryflow air filter that does not require oil and is very durable. This is used along with various makes like Honda, Mercury, Volkswagen, Suzuki, Eagle, Saturn, Isuzu, Plymouth etc.

Airaid cold air intake system can be installed in 30 minutes. It enhances the horsepower and mileage. There is also more power per mile. Makes like Chrysler, Ford, Lincoln, Mitsubishi, Toyota and Cadillac use such systems.

Street performance cold air intake system is one of the most advanced airflow management technology. The components are of high quality and engineered for exact fit and function. Some of these may be made of high quality 16 guage steel.

Pacesetter cold air intake uses mandrel bent 3.5 inches diameter tubing for a perfect match between the engine requirements and power gain. A special powder-coat finish ensures minimum effect of underhood temperatures on inlet air temperature. A high volume cone filter with washable pleated element straightens the air before entering the intake tube of mass air flow sensor. The system can be installed in maximum 30 minutes and there is no need of any cutting or drilling. Vehicle makes like Chevrolet, Dodge, Ford, GMC and Jeep use this system.

AFE cold air intake system gains upto 50 horsepower and improves airflow upto 75%. The system replaces OE air box and filter and factory intake tube. The installation is very simple. The fuel efficiency and throttle response is also improved.

Injen cold air intake system is short ram intake system. This dyno tuned air intake system fits directly in the place of the OEM air intake system. Infiniti, Lexus, Mazda, Scion, Subaru are some of the makes that use this system.

Neuspeed cold air intake system has a super hi-performance, better throttle response and fuel economy and power. There is a 5-8 horsepower increase on a restrictive factory air box. There is a stainless steel heat shield and hi-performance filter. The filter can be washed and reused.

True flow cold air intake system is a unique departure from the traditional systems. The stock air filter is replaced with True Flow's high flow, foam air filter. The factory air tube is replaced with True Flow's powder coated, mandrel bent tube with reinforced silicone couplers. This results in maximization of velocity. This system retains all factory breathers, sensors and hoses.